1. Assemble the 4 poles onto the pins of bottom frame.
9. Slide the gift box over the top of the reservoir and rest on the base. Be sure to align the notch for the water hose.
2. Unfold reservoir and pull apart until bag resembles a square.
10. Place box in desired location and fill with (5) gallons of water.
RESERVOIR MUST BE COMPLETELY FILLED
WITH (5) GALLONS OF WATER FOR SYSTEM TO WORK
PROPERLY.
3. Insert hose over barb located on the lower left hand corner of the reservoir.
11. Install the reservoir cap, and then check for any leaks.
4. Slide reservoir in between the poles and bottom frame.
12. Find the two strings in the ribbon of the pull-bow.
5. Install the top “X” frame to all 4 poles.
13. Pull the two strings while holding the base of the ribbon.
6. Zip tie the valve to the tree 4 inches above the desired water level. Bend the wire in the "L" bracket until the valve is as close to straight up and down as you can get it.
14. Pull strings until ribbon resembles a bow. DO NOT CUT STRINGS YET.
7. Connect the hose to the valve and slide the valve up or down until the white line is at the desired water level.
15. Insert strings through die cut slots located on the outside center of the gift box lid and tie them together to secure bow.
8. Open the Gift Box.
16. Sit back and enjoy not having to water the Christmas tree this season.
